Folks,

When comparing the volume of solder paste provided by a circular versus square aperture, consider that if the side of the square is D and the diameter of the circle is also D, the square has greater than 25% more area. (i.e., (1-0.785)/0.785 = 0.274). See Figure 1.

Figure 1. Square vs. circle areas.

However, the greater area of a square is not the only reason square apertures deposit more solder paste. The curving of the circular aperture enables more surface of the stencil to contact more of the solder particle’s area. See Figure 2. So, the solder particles will adhere to a cicular aperture more readily and not adhere to the pad, resulting in a smaller solder paste deposit. 

Figure 2. The curving of a circular aperture results in more contact area with solder particles than a square aperture

These two effects can result in dramatically different soldering results, as seen in Figure 3. Using the square aperture provides so much more solder paste; when compared to what a circular aperture provides, it is stunning in the soldering result.

Figure 3. Circular aperture/pad (left) and square aperture/pad (right), using the same Type 3 powder size, area ratio, flux chemistry (no-clean), and reflow profile (RTP)

Cheers,

Dr. Ron